Project records, published without client names
Configuration, method and findings are published as delivered. What is left out is the client — a blade manufacturer does not usually want the instrumented section of a blade in development to be public.
20,480 points across a 2.5 m² blade panel
Five long sheets and ten compact collectors merged into one continuous map over 1040 × 2480 mm, then compared against the aerodynamic model.
Bond-line pressure during spar cap bonding
Adhesive pressure mapped along the bond line before cure, replacing a trial-and-error shim routine.
Press platen uniformity before a curing change
40,960 points across ten sheets measured platen flatness under load, so the process change was decided on data rather than a sample.
Gripper contact pressure on composite parts
A single 4096-point sheet on the finger surface mapped contact pressure, exposing two points that exceeded the damage threshold.
What is not on this page
No client names, no plant locations, no commercial terms. Configuration drawings, the full pressure dataset and the deviation report for any record can be reviewed under a mutual NDA — start with the contact form.